Need some help with a nut on the Banshee cylinders

Started by TurboBanshee_kid, November 05, 2005, 02:49:29 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

TurboBanshee_kid

November 05, 2005, 02:49:29 AM
Need some help with a nut on the banshee's cylinders. It was strip when I was taking the cylinders off for porting. How can i get it off?

Thank you guys so much :'( I want the porting :'(

[attachment deleted by admin]
New to the Engine 421cc Cheetah Cubs that are fully race ported, Hot Rods 4mm Stroker Crank, Ricky Stator fly wheel and 200watt stator also timing plate is at +5, NOSS Head with 17cc domes, V force 3 reeds and 36mm MIKUNI Flat Slide carbs

TurboBanshee_kid

#1
November 05, 2005, 02:50:54 AM
More

[attachment deleted by admin]
New to the Engine 421cc Cheetah Cubs that are fully race ported, Hot Rods 4mm Stroker Crank, Ricky Stator fly wheel and 200watt stator also timing plate is at +5, NOSS Head with 17cc domes, V force 3 reeds and 36mm MIKUNI Flat Slide carbs

cutngrs

#2
November 05, 2005, 03:03:05 AM
pull the head off  and the other cylinder  off   this should give you a nuff room to use a pair of vise grips   i have set of cylinders that are all ready ported with big bore sleeves but they are only at a 64.75 bore i have pistions too  all new never put on since done

[attachment deleted by admin]
THE ORANGE CRUSH BANSHEE  
WWW.MYBANSHEE/IS/FASTER/THAN/YOURS.COM
IF YOU WANT TO RUN WITH THE BIG DOGS GIVE US A CALL

TurboBanshee_kid

#3
November 05, 2005, 03:05:49 AM
Hey thanks very much!
New to the Engine 421cc Cheetah Cubs that are fully race ported, Hot Rods 4mm Stroker Crank, Ricky Stator fly wheel and 200watt stator also timing plate is at +5, NOSS Head with 17cc domes, V force 3 reeds and 36mm MIKUNI Flat Slide carbs

Chillinthemost

#4
November 05, 2005, 04:10:31 AM
Make sure you use a 6 point socket
YFZ  FTR B-Open  #12
Chillin Jr. FTR Super Pee A #12
Print
Go Up Pages1
User actions