30 inch mudlites

rubicon500kid · September 19, 2005, 05:26:10 AM

i found out there is 30 inch mudlites they got 1 1/2 lug and there is pics to prove it
Here you all go:
http://pg.photos.yahoo.com/ph/mcmullen_g/detail?.dir=6deb&.dnm=42a6.jpg&.src=ph

TRX350_On_The_Rack · September 19, 2005, 10:35:06 AM

I want 'em :ThumbsUp.gif

............but I need more motor.

rubicon500kid · September 19, 2005, 03:50:41 PM

i know i got 27 inch vamps on my rancher i wonder if i could hanedl 28 inch lites

FOREMANRON · September 19, 2005, 03:53:17 PM

I WOULD STAY WITH THE 27S I HAD 26S WHEN I HAD MY RANCHER AND IT COST ME A REAR END

JustC1582 · September 20, 2005, 05:00:14 AM

My 26 inchers work just fine!

It's a great tire

rubicon500kid · September 21, 2005, 09:53:53 AM

how did 26 cost u a rear end ?

TRX350_On_The_Rack · September 21, 2005, 10:47:43 AM

Quote from: rancher350kid on September 21, 2005, 09:53:53 AM
how did 26 cost u a rear end ?

One thing you have to keep an eye on is water getting in the rear and frontend. I have seen a few that have got water in them and the gears don't last long after. I check mine if I drive through deep water. I've been lucky so far considering I had the bike in pretty deep water.

[attachment deleted by admin]

FOREMANRON · September 21, 2005, 11:20:31 AM

I AM NOT FOR SURE BUT SOMEBODY WHEN YOU LIFT THEM IT PUTS AN ANGLE ON THE REAR END. ONE DAY I WAS PULLING ON SOMEONE HAD TO GIVE A LITTLE SNATCH ALONG WITH THE SNATCH CAME A SNAP. THEY WERE NOT GOING TO WARRANTY IT BUT THEY FINALLY DID THANK GOODNESS

rubicon500kid · September 21, 2005, 01:18:11 PM

oh ok how do i check my dif to see if water is in them i got all my vent lines snorkeld up to my handel bars

TRX350_On_The_Rack · September 21, 2005, 01:26:47 PM

Quote from: rancher350kid on September 21, 2005, 01:18:11 PM
oh ok how do i check my dif to see if water is in them i got all my vent lines snorkeld up to my handel bars

Aluminum cast nut on the top of the rearend and frontend. Fluid should be not be milky.

rubicon500kid · September 21, 2005, 01:48:46 PM

ok il check it later today if it is kinda milky what should i do

TRX350_On_The_Rack · September 21, 2005, 02:26:53 PM

Well, what I did on my friends bike was I jacked it up, took out the drain plugs on the bottom. (Note: the rear-end also has an inspection bolt on the bottom side. You want to remove the bolt on the bottom under the rear-end guard). I drained the fluid, put in some diesel fuel, spinning the wheels by hand, putting my finger over the drain plug and then letting it drain. Did this a couple of times and then let drain completely. Put new oil in, ran bike for a short time while still jacked up and then drained the oil and refilled again. I prefer to use regular oil for the draining process to save money, 8oz bottle of Honda Hypoid oil is about $10. The front-end takes 8.2 Ounces and the rear 2.9 Ounces. The oil Honda recommends is Hypoid gear oil SAE 80.

Bigscrb15 · September 21, 2005, 02:51:36 PM

I can't wait til they have 35's. lol. hmmmm, actually I think I just need some 49" Trxus on my quad, dirt1 i need help with that! lol j/k

LT-R450ApK · September 21, 2005, 05:39:27 PM

i think thats photoshopped ive looked everywher for them itp doesnt show them on their site either....

Ill have a set if it is real though

rubicon500kid · September 21, 2005, 06:11:55 PM

they have not bine released yet on there web site but go to high lifter and look in there fourms

Bigscrb15 · September 21, 2005, 06:13:05 PM

yea they will be out soon, i have hear about them before.

rubicon500kid · September 21, 2005, 06:14:43 PM

if i get more $$$ and get a clutch kit for my bike i will try to get them cuz i want to have the badist rancher around