Water 4 Gas

[big-daddy]

ON THE 3.0 RANGER YOU WILL NEED THE EXTENDERS 3 OF THEM , 1 EACH SIDE OF EXHAUST BEFORE CAT AND 1 AFTER CAT AND THEN YOU SHOULD SEE LIKE 7-8 MPG'S AFTER ABOUT 1 MONTH OF CONSTANT USE, ATLEAST THATS WHAT I'M GETTING25-26 MPG'S AND I WAS GETTING 17-18 BEFORE USING AND I HAVE 2 GENERATORS HOOKEP UP NOW

You dont need one on the down side of the exhaust, that rear sensor only check if the cat is bad.

[JackL]

Necessity spurns innovation, that is for sure.


Check this out: http://www.sciencedaily.com/releases/2008/02/080222095427.htm

[TRX450R_Racer]

I will be installing my 4 cell system either tomorrow or Sunday. It depends on when my friend has time to weld me up a mount. I just finished putting them together.

[big-daddy]

dang frank that look good, what are you install them on?

[TRX450R_Racer]

dang frank that look good, what are you install them on?

Thanks

I'm putting it on my 99 Sierra, 4X4, 5.3L, that is lifted on 35s. It gets 12-13 MPG right now.

[Turboderf]

I will be installing my 4 cell system either tomorrow or Sunday. It depends on when my friend has time to weld me up a mount. I just finished putting them together.

Sweet Bring it over

[big-daddy]

dang frank that look good, what are you install them on?

Thanks

I'm putting it on my 99 Sierra, 4X4, 5.3L, that is lifted on 35s. It gets 12-13 MPG right now.

What are you going to do to the FI system?

[TRX450R_Racer]

I have spacers for the O2 sensors. I'm injecting the gas after the MAF sensor. I don't know about the MAP sensor. I will see what happens. I might add the O2/MAF controller later.

[big-daddy]

Do you have a MAP or MAF sensor?

[ROC0999]

Do you have a MAP or MAF sensor?

Where can you get one that works and not cost an arm and a leg?

[big-daddy]

It cost about $35.00 for a dual (city and highway)and $25.00 for a single to make

[tekhanto]

Way to go BD sounds like you have this thing figured out !!!!!!

[TRX450R_Racer]

Do you have a MAP or MAF sensor?

I have both.

[miami_rider#13]

does water for gas really work? lol

[big-daddy]

Do you have a MAP or MAF sensor?

I have both.

You have the one thats both together on the same unit. Is it a 5.0 (305) or a 5.7 (350), I didn't know there was a 5.3?

For that unit you install a resistor in the ground wire, between 10 to 15 ohm is the normal and 30 ohm Max. 

[ROC0999]

where can I get the dual for 35.00

[big-daddy]

does water for gas really work? lol

Better than this........... Assume the position!

[big-daddy]

where can I get the dual for 35.00

You have to build one, if you want me to build one for you...... well thats a different story.

[TRX450R_Racer]

Do you have a MAP or MAF sensor?

I have both.

You have the one thats both together on the same unit. Is it a 5.0 (305) or a 5.7 (350), I didn't know there was a 5.3?

For that unit you install a resistor in the ground wire, between 10 to 15 ohm is the normal and 30 ohm Max. 

1999 and up the Sierra and the Silverado 1500s no longer had a 5.0 305 or a 5.7 350. It went to a 4.3 V6, 4.8 V8 or a 5.3 V8. The MAP sensor is seperate from the MAF.

[miami_rider#13]

lmao so it does work?

[TRX450R_Racer]

Here are the mounts we came up with. There wasn't room to put all four on the same side of the engine. Two will be on the drivers side and 2 on the passengers side. I still have to wrap them in foam. I will show installed pics later.

[ROC0999]

Looks good Frank

[gtnwood]

Can you use recycled beer, instead of just water?

[jrpro130]

I still want big daddy to make me one!!!

[yunt2ride]

Do you have a MAP or MAF sensor?

I have both.

You have the one thats both together on the same unit. Is it a 5.0 (305) or a 5.7 (350), I didn't know there was a 5.3?

For that unit you install a resistor in the ground wire, between 10 to 15 ohm is the normal and 30 ohm Max. 

BD, in 1999, GM built both, the old body dtyle truck and the new body style truck. He has the new body style. Good job TRX.