Timberwolf engine swap question

[yunt2ride]

I am putting a 1996 yamaha timberwolf engine in a 1992 timberwolf quad. Everything fits except the wiring. The old quad engine had 6 wires coming from the engine and the 1996 engine has 7 wires. I know that the four together should go to the same places as the four prong but on the old engine there was 2 other wires and the new engine has 3. On the old engine one of the wires was yellow and the other was white. On the 1996, all three wires are white. HELP. How can I wire them up. Has anyone done this before. Thanks

[yunt2ride]

Anyone

[IT200]

Yamaha used different stator configurations through the years go to www.rickystator.com call rick and he can help you get the wiring right.

[yunt2ride]

Yamaha used different stator configurations through the years go to www.rickystator.com call rick and he can help you get the wiring right.

UPDATE, Ricky told me that the three wires off of the 96 model will not interchange with the 92 model. He said that the 96 model was three stage and the 92 model was single state. I cannot beleive that both of these engines are the same, except this. Can anyone give me any other suggestions. Thanks