Spacers

[Teej]

What is your take on Wheel spacer bolts? Are they as safe and durable as other wheel spacers?

Teej

[BIGWORM3699 ( ECP RACING)]

They are ok and seam to work fine. You may have to do machining if used on the front.Just dont go crazy with the spacing 2 to 3in. is the max I would go. We run the on our LT80 with good luck but had to machine them down to fit around hub on the frt. Hope this helps. Look at my signature for our link to our site.

[Joedirt]

My buddy had some on his Foreman and unless you check the Lug Nuts  regularly they could loosen and cause the stud to break. Maybe this was a one time thing but I figured I would share.

[Teej]

What about the mud and dirt? Putting 3" spacers on will bring the tires out past the fenders. Well this bring sand and mud right up into his face if I change them?

What is your take on spacer studs increase either 3" or 5" ? Is 5" too much?

What if I spaced the back end 5" and the front end 3"?

Thanks, Teej

[BIGWORM3699 ( ECP RACING)]

You will be ok with 1.5 ea side frt and 2.5 each side rear it wont put to much stress in the frt steering. We are a total of 8in in the rear of our xtreme thats with rims and spacer combo. But we used full spacers not the bolt style spacers.

[Teej]

You will be ok with 1.5 ea side frt and 2.5 each side rear it wont put to much stress in the frt steering. We are a total of 8in in the rear of our xtreme thats with rims and spacer combo. But we used full spacers not the bolt style spacers.

Where did you get your full spacers from? Thanks