Messages

Thanks! I found a online diagram of the carb and you're right. It's the drain hose. That isn't a filter, but a one way inline valve. I'm not sure what valve you're talking about. When I tace the tube back to the carb it just goes in the bottom. Where's the valve and how does that fix the problem?

A couple of weeks ago I noticed the smell of gas in my garage, but I couldn't figure out where it was coming from. Tonight I was riding around my pasture when I suddenly stalled out. I looked at the gas gauge and I was empty. It was over half full a few days ago and I haven't ridden anywhere. I switched over to reserve and it fired right up and I got home fine. I started looking around underneath the ATV and could see gas dripping off the right rear skid plate. I finally found a small black hose hanging loose on the right side next to the pull start. The hose runs down through a small retainer and there's only about 3-4" of hose once it passes through the clip, so whatever it came off of has to be close. The hose is in good shape and doesn't appear to be broken. I felt around the best I could and can't find what the hose fell off of. It appears that there is a tiny inline filter near the end of the those. I was wondering if the filter didn't block and blow the hose off. Any suggestions on where the hose goes? Any idea what this hose is?

Thanks in advance!

Someone posted the ATV size and weight requirements for Croom a while back. I have a Honda Rincon that is too wide, long, and weighs too much according to the posting. Is Croom strict on this or is my Rincon no problem?