Messages

Sounds good! Polk County is slightly closer though.

We built a big table top out of a pile of clay we had on that same job, and it was pretty big but when the clay was gone for use in the roads we planned on building one we could keep and just move where ever we wanted. The good thing is it will always be the same jump now. Before I would go and spend about an hour with a dozer getting everything smooth and we would ride on it for one day then the locals with utility 4-wheelers would mess the lip up and we would have to start over the next weekend. But other than the local tracks and the clay pile, this is the first metal jump I have ever done, and I have to say I LIKE IT!!

I have about $800.00 into with just material, labor I didn't count because I did it myself and it was kinda fun. But we have three people going in on it so it won't be but around #270.00 apiece.

It's in Dundee, the only job we have with a big enough pile of dirt.

This is the only picture we took before the battery went dead.  All went well the ramp DID hold up and everyone liked it. Hopefully I will have better pics next weekend.

I have enough left to do that but it feels pretty srtong laterly, after a good day on it and checking all the welds if it is needed I will weld the cross brace on it. It's all in mind.

Just let me make sure it doesn't fall apart then you are welcome to try all you want.

It will be in Dundee probably on Sunday. My son's first birthday is Sat. so Sunday is test time. I might not invite my two friends that didn't help me so (dirtbikers), meaning I might be the only quad.

Cost me like $800.00 to build and I was supposed to have two friends help me but the f-ers always had an excuse or didn't answer their phones. I guess I need new ones.

What are you gonna use to cover up the lip?

# 9 raised expanded metal

I used 6013 rods, you mean braces at a 45 degree angle?

It is as close to the rev 1 plans as I could get.

I don't have much metal left, do you think small lenghts in each corner of the back would work? Thanks for the input.

All  I need is the raised expanded metal for the top. I have a job in Dundee that has a large pile of dirt to use for a landing. If my broke a$$ friend gets off the money this week, Sat or Sun will be test day.

I do construction so I have access to dozers and such so my job has huge piles of dirt every where to manipulate into a landing.

Maybe only 1 friend, the other was supposed to give me $200.00 to finish so we could jump this weekend, but he was convienently unavailable.

Me a ltz 400 and 2 friends of mine with dirt bikes.

Just a few more dollars and it will be finished.

In lakeland. It is an eliptical radius.

Where is the link located?

http://i90.photobucket.com/albums/k272/kpmraiders/100_1870.jpg