ATV Florida Forum

General => Tech Corner => Topic started by: NYRAPTOR on December 19, 2005, 10:34:43 PM

Title: raptor starter
Post by: NYRAPTOR on December 19, 2005, 10:34:43 PM
it makes noise like its spinning but not turning engine over. do i need a new starter or did i wreck something else? thanks for your help. john
Title: Re: raptor starter
Post by: Moose on December 19, 2005, 10:40:56 PM
The little gear that spins the engine over isn't moving forward, it's stuck. Remove starter and see if you can clean and lube, then see if it works.
Title: Re: raptor starter
Post by: NYRAPTOR on December 19, 2005, 11:38:37 PM
thanks bro. i got the starter out. i'm going to give that a try. if not i guess its time for a new one. thanks again
Title: Re: raptor starter
Post by: atvtrailer on December 19, 2005, 11:41:47 PM
im not sure if the raptor is the same, but when that was happening on my 400ex, it was the starter clutch that had gone bad
Title: Re: raptor starter
Post by: NYRAPTOR on December 19, 2005, 11:54:49 PM
i read something about that to. i hope it's just the starter gear.
Title: Re: raptor starter
Post by: Da_Mtg_Man on December 20, 2005, 12:17:48 AM
Jon,

It's the one way bearing. Raptors are famous for that.
Title: Re: raptor starter
Post by: NYRAPTOR on December 20, 2005, 12:24:07 AM
does that mean just replace the starter? thanks mike
Title: Re: raptor starter
Post by: 01ZX12R on December 20, 2005, 12:57:30 AM
You need to replace the starter clutch not the starter. Raptor do seem to eat them up.
Title: Re: raptor starter
Post by: Moose on December 20, 2005, 12:59:29 AM
That's cool, didn't know they had a one way bearing, do now. Thanks