i found out there is 30 inch mudlites they got 1 1/2 lug and there is pics to prove it
Here you all go:
http://pg.photos.yahoo.com/ph/mcmullen_g/detail?.dir=6deb&.dnm=42a6.jpg&.src=ph
I want 'em :ThumbsUp.gif
............but I need more motor.
i know i got 27 inch vamps on my rancher i wonder if i could hanedl 28 inch lites
I WOULD STAY WITH THE 27S I HAD 26S WHEN I HAD MY RANCHER AND IT COST ME A REAR END
My 26 inchers work just fine!
It's a great tire
how did 26 cost u a rear end ?
Quote from: rancher350kid on September 21, 2005, 09:53:53 AM
how did 26 cost u a rear end ?
One thing you have to keep an eye on is water getting in the rear and frontend. I have seen a few that have got water in them and the gears don't last long after. I check mine if I drive through deep water. I've been lucky so far considering I had the bike in pretty deep water.
[attachment deleted by admin]
I AM NOT FOR SURE BUT SOMEBODY WHEN YOU LIFT THEM IT PUTS AN ANGLE ON THE REAR END. ONE DAY I WAS PULLING ON SOMEONE HAD TO GIVE A LITTLE SNATCH ALONG WITH THE SNATCH CAME A SNAP. THEY WERE NOT GOING TO WARRANTY IT BUT THEY FINALLY DID THANK GOODNESS
oh ok how do i check my dif to see if water is in them i got all my vent lines snorkeld up to my handel bars
Quote from: rancher350kid on September 21, 2005, 01:18:11 PM
oh ok how do i check my dif to see if water is in them i got all my vent lines snorkeld up to my handel bars
Aluminum cast nut on the top of the rearend and frontend. Fluid should be not be milky.
ok il check it later today if it is kinda milky what should i do
Well, what I did on my friends bike was I jacked it up, took out the drain plugs on the bottom. (Note: the rear-end also has an inspection bolt on the bottom side. You want to remove the bolt on the bottom under the rear-end guard). I drained the fluid, put in some diesel fuel, spinning the wheels by hand, putting my finger over the drain plug and then letting it drain. Did this a couple of times and then let drain completely. Put new oil in, ran bike for a short time while still jacked up and then drained the oil and refilled again. I prefer to use regular oil for the draining process to save money, 8oz bottle of Honda Hypoid oil is about $10. The front-end takes 8.2 Ounces and the rear 2.9 Ounces. The oil Honda recommends is Hypoid gear oil SAE 80.
I can't wait til they have 35's. lol. hmmmm, actually I think I just need some 49" Trxus on my quad, dirt1 i need help with that! lol j/k
i think thats photoshopped ive looked everywher for them itp doesnt show them on their site either....
Ill have a set if it is real though ;)
they have not bine released yet on there web site but go to high lifter and look in there fourms
yea they will be out soon, i have hear about them before.
if i get more $$$ and get a clutch kit for my bike i will try to get them cuz i want to have the badist rancher around