I just got this Tri-Z jug, YTM jug and YTM head back from the machine shop. I want them shiny black, but they are made out of aluminum and I know you can not use regular engine paint on aluminum. Give me some ides you all. I really want to get this back on the trikes as soon as possible.
[attachment deleted by admin]
More photographs.
[attachment deleted by admin]
Powder coat. Tougher and lasts longer, also withstands heat well.
Really. I never knew it could handle heat. I will look into that. Thanks.
ATP does good powdercoat work.
Yep call NightBreeder..I mean Breed . ;D
Where are they located?
They are in Apopka email them atpracing@earthlink.net or call 407-880-3171
That is not too far. I will get in touch with them. Thanks.
If I may say so... powdercoating might be too thick
and cause over heating problems. Your best bet is
an etching primer(usually applied thin) followed by
some type of high heat gloss black(thin as well).
Just put enough paint on until it is covered.
Just my two cents, your mileage will very. Goodluck.
Hope it turns out for you.
Dano out
we do powder coating and it will not cause it to over heat. that your best choice