|
Title: bumper #3 Post by: shawnley1222 on September 15, 2008, 04:56:40 PM thinkin about this route this go around just gotta decide 45 with a bevel or corner to corner.... im leanin towards the 45ed w/ bevel
(http://i117.photobucket.com/albums/o48/shawnley1222/rhino/e395a9c6.jpg) (http://i117.photobucket.com/albums/o48/shawnley1222/rhino/f0b5b10a.jpg) p.s. silver is where it will be welded and the braces are jsut drawn in not in "exact" placement Title: Re: bumper #3 Post by: Muddbuggy on September 15, 2008, 09:03:13 PM what are you trying to build ? from the drawing it looks like a A-arm with a wheel
Title: Re: bumper #3 Post by: Muddbuggy on September 15, 2008, 09:04:52 PM aw shizit I just had to post again cuz my post count was 666
Title: Re: bumper #3 Post by: MuddFreak77 on September 15, 2008, 09:36:13 PM what are you trying to build ? from the drawing it looks like a A-arm with a wheel Looks like a bumper... :o :P Title: Re: bumper #3 Post by: shawnley1222 on September 15, 2008, 10:43:33 PM it is a bumper i drew it today in like 2 mins so i didnt forget what i wanted to do and to get the measuremtns 4 the rhino and ya its a sloppy drawing for a bumper
Title: Re: bumper #3 Post by: Muddbuggy on September 15, 2008, 10:57:50 PM what are you trying to build ? from the drawing it looks like a A-arm with a wheel Looks like a bumper... :o :P shawnley is it for the rear and bolt up under the bed? Title: Re: bumper #3 Post by: shawnley1222 on September 16, 2008, 04:59:57 PM ya its for the rear and will bolt under bed 1st one i made i couldnt dump the bed very much so made number 2 and a week or so ago i tried hookin the trailer to the rhino and coulnt so makin a new one but has now been postponed seein how i found out today that tomorrow is my last day cause i got laid off :(
Title: Re: bumper #3 Post by: Muddbuggy on September 16, 2008, 06:50:14 PM damn dude that sucks....im sorry to hear that :(
Title: Re: bumper #3 Post by: shawnley1222 on September 16, 2008, 07:12:16 PM anybody know of any work for a laid off welder???? :-\
|