Print Page - CLUTCH PROBLEM WITH THE BANSHEE

Title: CLUTCH PROBLEM WITH THE BANSHEE
Post by: TurboBanshee_kid on April 11, 2005, 03:41:31 PM

it is not going in to neutral when the bike is running and is in first gear but when the bike is shut off it goes in to neutral

WHAT DO I NEED

Title: Re: CLUTCH PROBLEM WITH THE BANSHEE
Post by: NYRAPTOR on April 11, 2005, 06:47:14 PM

have you adjusted the clutch cable? you might be able to get away with that so it engages better. johnny

Title: Re: CLUTCH PROBLEM WITH THE BANSHEE
Post by: TurboBanshee_kid on April 11, 2005, 08:00:17 PM

I will try that

Title: Re: CLUTCH PROBLEM WITH THE BANSHEE
Post by: ish on April 12, 2005, 07:54:51 AM

all the banshees have issues with getting into neutral when the bike is running. adjusting the cable is a good idea.

Title: Re: CLUTCH PROBLEM WITH THE BANSHEE
Post by: Bigwilly on April 12, 2005, 08:16:00 AM

i have found that it is easier to go into 2nd & click half way down then half way up also what kind of clutch did you put in it ?? barrnett dirt digger's forget it ebc are a lil better this is based on my 10 years of playing with these dang money pits LOL good luck willy

P.S. do you know where the clutch points are on top of the case ??? make sure thay are lined up. if not look on the top left side of the case when you pull the clutch you will see a piece move with a arrow on it & there is another arrow on the case itself thay shoud be lined up point to point. hope this helps willy

ATV Florida Forum

General => Tech Corner => Topic started by: TurboBanshee_kid on April 11, 2005, 03:41:31 PM