I charged the battery and put it in my atv and It tries to start, but on the digital display it flashes "volt" and then it will flash "belt" :dunno.gif Any help would be great.
Battery is bad. Sounds like it's not holding enough charge to turn the bike over.
Bill
Try Arcticchat.com , register and post your question .
I've had most of my questions anwered there , good site .
http://www.arcticchat.com/
Good Luck
ya go get your battery tested even if it is brand new and charged, i had a dead battery and didnt know it but i replaced the battery just to be safe and then i got into the engine and looked at the stater and starter gears and checked all the wiring and turns out the place sold me a bad battery and so took it back and got a new one it is always the simpelist thing. :}} :}} :}}
Thanks alot to everyone who replied to my post. I think that I might charge my battery on trickle charge and reinstall it on my ATV.
I put a winch on my King Quad several months ago and ever since then it won't start with the starter, I would have to pull start it. I made sure I had the terminals tight several times but still would not start with the starter. I removed the battery and had it tested and they said it was good and so I re-installed it but this time I was very careful to make sure everything was seated snug on the terminals and now it works fine. Evidently I had something that was not making good contact even though I had them down tight. I would start from there if you have not done so already. Good luck