hey, i was lookin at my z, and noticed that theirs no screws holding in the grab bar, and that it is apart of the sub-frame, what would i do if i were in need of a new bar?
Some JB weld and duct tape. ;)
Congrats on the Z
If you were serious about getting into woods racing, let me know Ill start you off with the right mods.
YOU HAVE 1 OF THE OLDER SUBFRAMES THEY MADE 2 DIFF STYLES
YOU NEED TO GET THE OTHER SUBFRAME IF YOU WANT A CHANGEABLE GRAB BAR
The 400ex's are the same way. alot of 400ex parts fit on a Z400 almost identical bikes. But the Z has a much better motor and all around charecteristics from a few tweaks Suzuki did.
They make an aftermarket grab bar that clamps on.
i got one on my 400ex its U bolts and it holds on taht way
Quote from: TRX450R_Racer on January 09, 2006, 01:57:02 AM
They make an aftermarket grab bar that clamps on.
how much do they cost and where can i get them
hey svt, ill see what happens ;)
mine is a 6 pack its a pmr
Efren, PRM not pmr. lmao . ure always confusing it. go look at ure grab bar. lol