96 Warrior Carb Question

Started by fastang, November 20, 2008, 05:19:22 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

fastang

November 20, 2008, 05:19:22 PM
I just put a used carb on my 1996 Yamaha Warrior. It will only idle when the idle screw is all the way. Also it sputters and blows a little black smoke until I have it about half throttle.

Any suggestions?

Thanks!

fastang

#1
November 20, 2008, 05:21:00 PM
Also, I have a rebuild kit for it.  If there is anyone near Eglin AFB that would rebuild it for cheap, PM me.

TRX450R_Racer

#2
November 20, 2008, 09:37:03 PM
Quote from: fastang on November 20, 2008, 05:21:00 PM
Also, I have a rebuild kit for it.  If there is anyone near Eglin AFB that would rebuild it for cheap, PM me.

If you were near West Palm Beach I would do it.
Member of South East Florida Trail Riders

Life's to short, wear a helmet.
Dress for the crash, not for the ride.
Ripped off by Brandon George.

crom A zone

#3
November 20, 2008, 09:49:46 PM
sounds like the float is not workin    at low revs or the diphrame  is broken
2008 brute force 750

30inch itp mulite xxl on ss108s
rad reloated and mimb snorkles
gold/red epi clutch springs
hl springs and extream 2inch lift

scrimmy

#4
November 21, 2008, 06:11:56 PM
send it to me i will rebuild it for nothing.

fastang

#5
November 22, 2008, 02:16:30 PM
Thanks for the offer, but I bought the book and went ahead and did it myself.  She runs like a champ now.
Print
Go Up Pages1
User actions
Other Florida sites of interest: www.PinballShark.com