Correct PSI

[CAOSPOP]

What do you think would be the correct PSI for a Utility Quad  

[Moose]

I have a 450 foreman, factory says;
front and rear 3.6 to 4 psi.

I run it there and it rides as good as a foreman will ride, soft tires help out.

[CAOSPOP]

When I bought my VINSON 500 they told me 3psi. I'm glad im getting differnt opinions.

[LT-R450ApK]

Im Running 3 psi in my 28's

[Da_Mtg_Man]

I was running 1psi in my Outlaws so I bumped it up to 3, We'll see how it rides now.

[ucfneed2ride]

Wow, i am running way too much...

[Da_Mtg_Man]

I forgot to mention that I broke the outer bead at 1psi when I was in some thick thick 4 ft deep muck. Thats why I rasied it to 3psi.

[bbf]

i run 5psi in the outlaws & mud lites

[TRX350_On_The_Rack]

Depends on conditions. Hard ground 5-6 psi. Soft Ground 3-5 psi.

[CAOSPOP]

I just had new tires and I had the guy at that tire put them at 36 psi !!!. I held it there for about 30 min. then i brought them back down to 3psi so the bead would set.

[innocent_bystander]

I run my tires at a high psi. I got 28" Highlifter outlaws and run them somewhere around 10. The suggested psi for my tires is something like 6.

[TRX350_On_The_Rack]

Have you tried reading the side of the tire

[CAOSPOP]

On my stock dunlops it doesnt specify. Just not to go above 36 when saeling the bead.

[TRX350_On_The_Rack]

That's fine for sealing, but should be dropped down right after, but more important is these tires are designed to run low psi. I never go below 3 psi and above 6 psi. No problems as of yet.