driveshaft?

[backwoods boy]

i forgot to mark top or bottom on my driveshaft and am not sure wich way to put it in what will happen if i put it in 180' the wrong way its the rear shaft on an 88 fullsize blazer

[Chillinthemost]

it will be fine

[crom A zone]

look at the angle  if u put it in backwords will be to steep of an angle of rear end and bind yr u joints check before bolt it on bigger u joint goes towrds the rear end

[Chillinthemost]

look at the angle  if u put it in backwords will be to steep of an angle of rear end and bind yr u joints check before bolt it on bigger u joint goes towrds the rear end

If I understand you right, you think he means front or back. His driveshaft will have a slip yoke on the tranny side and cant go but one way. I'm assuming that he unbolted it from the rear end and is worried about how to bolt it back to the diff., if thats the case then just bolt it up and go.

[crom A zone]

if its 4x4 they bolt on both sides an are  2 diff size u joints smaller u joint gos in the front bigger in the rear  there is not a ibg size diff but it will keep snapping the u joint if put in wronge

[Chillinthemost]

if its 4x4 they bolt on both sides an are  2 diff size u joints smaller u joint gos in the front bigger in the rear  there is not a ibg size diff but it will keep snapping the u joint if put in wronge

Not going to argue with you, being that you are 4X4Matt you must know it all.

[backwoods boy]

no i know wich is front and back but im worried about top and bottom it can goin in 2 different ways like 180' upside down

[TRX450R_Racer]

I agree with Chillin, bolt it up and go.

[Anoriginal]

Bolt it up and go. You'll be just fine.

[Chuck_Norris]

If it breaks then you didn't put it in right

[crom A zone]

no it does not matter top and bottom its all the same

[gtnwood]

If it breaks then you didn't put it in right