Warrior Starting Problem

Two-Fast Yfz 450 · January 03, 2008, 01:09:55 AM

I cant get my warrior to start it turns ove but will never start it has a new cdi box and a new stator i need help to get it to start thanks

TRX450R_Racer · January 03, 2008, 02:19:19 AM

Do you have spark? Do you have fuel? Do you have compression?

k.p. · January 03, 2008, 02:20:36 AM

happened to me too
turns out some of my wires were loose...try tightening all your conections.

Two-Fast Yfz 450 · January 03, 2008, 02:24:10 AM

It has fuel and it has compression and it has some spark but not that much. I had put a dyno ignition box on the bike and it had fried the electrical system and stator. I got it fixed and it ran so than we got a new dyno ignition box and it fried the stator here agian but i put on a new stock cdi box and replaced the stator but now it wont start

TRX450R_Racer · January 03, 2008, 02:38:29 AM

Check the ground for the coil.

Two-Fast Yfz 450 · January 03, 2008, 02:45:47 AM

Well when it went out i was actually racing it and than i took it home and put in the new stator and cdi box and now it doesnt drive.lol

lugnuts · January 03, 2008, 04:33:58 AM

what kind of stator did you get ie:factory,rick stator I only ask because I just had the same problem with a warrior and it was a new stator from rm stator the new stator was bad had to get another one
there is a ohm test you can do to check the stator to see if its ok also make sure battery is fully charged low voltage can cause erratic/weak spark

steve