help bike wont start

Started by #21yfz, April 19, 2007, 06:17:05 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

#21yfz

April 19, 2007, 06:17:05 PM
well i have an 06 yfz...yesterday my bike started...and today i went to install a new starter button to replace the factory mounted one with the lights n all that stuff...all i did was cut the wires that go to the (red slider)on/off switch and tied the two together so that its always on...then i tested to make sure it works...and my bike turns over but wont fire...and i put it back to stock and it still wont start...but still turns over...i checked to see if i have spark and i do..and i put a new spark plug in as well..any suggestions or anything that could help? thanks ahead of time

TurboGSXR

#1
April 19, 2007, 06:43:45 PM
Not being a wise ass, try turning the gas on? 
(2) 2003 Honda Rincon 650, DGL, HMF Pipe, Power Now!, HighLifter Springs, HighLifter 2" lift, Gorilla 6"lift, ITP 30" tire combo, Kimpex front and rear bumper, Kimpex front and rear cargo boxes, Radiator spacers, Heavy duty fender cket eliminator, ATV Guru rear hitch, K & N Air

#21yfz

#2
April 19, 2007, 07:27:12 PM
lol yea it was on...but the thing was clogged...i had to pull it out of the gas tank n clean it out...thanks though

rdm225

#3
April 26, 2007, 10:31:31 PM
I BET YOU BLEW A IGN FUSE

Bounty1

#4
April 28, 2007, 02:14:53 AM
did you get it running?

#21yfz

#5
April 28, 2007, 12:27:59 PM
yea i got it running    :) but now i split the cases open  :'(

Chuck_Norris

#6
April 29, 2007, 11:41:28 PM
Quote from: #21yfz on April 28, 2007, 12:27:59 PM
yea i got it running    :) but now i split the cases open  :'(

How'd you do that?

#21yfz

#7
May 02, 2007, 05:40:28 PM
chain fell off and shot forward...i didnt realize i had the rear spocket on the wrong side of the hub part that holds the sprocket.. :banghead.gif
Print
Go Up Pages1
User actions
Other Florida sites of interest: www.PinballShark.com