HomeMade HRC airbox lid and flap.

[Miami450R]

Well im not really too good on $$ so instead of spending like 60 dollars or so on a actual HRC lid and flap , I modified my stock one to look and function like it,,,
this is what a Stock Lid looks like:

thats my lid:



This is a HRC lid.I found this pic on 450r hq , Dont mind the burned part of it , but look at the hole , and flap...


By the way: for those who are wondering , I had to cut it because i rejetted my bike to a 180 main jet , and i would have to run open airbox , but i ride trails alot , so this gives me the air AND the protection I need

Not too Shabby Ehhh?

[4fittyr]

 nice engineering   

[The hyrbid kid]

182 main jet no lid   

[1FasterBlaster]

   Mine has square hole cut out on the top with a silk screen cover.Breatheable, yet waterproof.

[Miami450R]

well i ran a 180 because i have a yoshi slip on and stock filter, it runs like its never ran before. I am EXTREMELY happy with it.

[Ida_Mann]

nice job,,,looks better than what you could buy.

Id@

[TRX450R_Racer]

Nice!

[gearhead400]

nice job,,,looks better than what you could buy.

Id@

i agree 

[Young Gun]

You could make those and sell them for cheap.  What did you use to cut out the section?

[Miami450R]

I used my dad's Compressor with the Hi-speed cutter (disc).

then i used a little wool brush tip with the compressor  , and smoothed out the edges and rough spots. lol.



Thanks.