FUSE POPPING EIGER

Started by Grassman68, October 04, 2006, 10:02:06 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Grassman68

October 04, 2006, 10:02:06 PM
 My eiger keeps blowing the ignition fuse.Could it be a bad relay? Should relay switches make noises and pops when starting bike?  couldnt find any shorts in the wiring as far as i could see. any suggestions would be appreciated !! :F :F :F :F :F :F :F

MuddFreak77

#1
October 04, 2006, 10:28:39 PM
Hey Dave,  Did you take all of the plastics off and see if there was a wire pinched??  The only time I've seen a relay click when starting is when the battery was dead or the starter was bad.

Carl
Never argue with an Idiot. They drag you down to their level, and then beat you with experience!


'07 Suzuki King Quad
3k Warn Winch
GPS

2001 F-250 4X4 Diesel, 6 way hand

UncleRico

#2
October 04, 2006, 10:35:02 PM Last Edit: October 04, 2006, 10:42:20 PM by UncleRico
check the rear brake light switch..(the one on the foot pedal) for some crazy reason they use the same circuit, they short to ground through the center (where the spring attaches to the pedal)


Any mishaps or accidents prior to this happening? Stick or log or rock hit the machine, in the area of wiring, hard lately?
Next time its idleing..start wiggleing the wire harness, is very small sections. If you can get the fuse to blow by wiggleing specific areas, then look for a wire with the insulation exposed to the frame or other ground.

UNLUCKY #13 RACING  "I want to thank my sponsors, Jack Cass Bail Bonds, The Cleveland Steamer Carpet Cleaner Company, The Rusty Trombone Pub, and Dirty Sanchez's Liquor and Check Cashing."

Grassman68

#3
October 05, 2006, 10:21:16 AM
The relay clicks and the fuse blows at the same time , i held the relay and waited for fuse to pop, when it did you could feel some thing in relay pop violently.  by the way thanks for the 8 mile tow service Carl.  Ill try the foot brake switch Uncle rico, thanks                                                                                                                                                                                                                                    grassman      :banghead.gif :banghead.gif :banghead.gif

Grassman68

#4
October 05, 2006, 06:02:56 PM
Unclerico ,  you were completely right  it was the brake switch.  It was grounding out of the switch and through the spring to the frame.I cant thank you enough i was racking my brain on this one. Any way enough but kissing have a good one.                                                                                                                                                                                                                                                                grassman

UncleRico

#5
October 05, 2006, 06:10:08 PM
Hey, glad that worked out for you. 


That's what Uncle Rico is here for, to help my peeps!
UNLUCKY #13 RACING  "I want to thank my sponsors, Jack Cass Bail Bonds, The Cleveland Steamer Carpet Cleaner Company, The Rusty Trombone Pub, and Dirty Sanchez's Liquor and Check Cashing."

wilburz

#6
October 06, 2006, 07:40:37 AM
You are the man UncleRico! Gracias senor! The eiger rides again!!!!! 8) 8)
1978 ridin mower, 48 inch cut, 3.4 hp briggs & stratton
12-6-3 front
14-8-5 back
no muffler

Busta Nutt

#7
October 06, 2006, 06:46:20 PM
Grassman you owe UncleRico a reach-a-round for that. At the very least a grass sample ;)
Print
Go Up Pages1
User actions
Other Florida sites of interest: www.PinballShark.com