blaster runs great after its warmed up

[cr1]

got a blaster that idles good and is good almost to mid throttle. at full throttle it acts like its starving for gas.once it is warmed up it runs perfect.i have cleaned carb checked all fuel supply even checked reed valves everything good , anyone have similar problems ??

[53yfz450]

isnt that how it normally goes. you have to let the bike warm up. i think you have nothing to worry about just let it idle for a little before you ride it.

[Hondarider22]

its worse with 2 strokes....with my cr 85 i would have to let is idle up to 2 minutes before running it full throttle 

[Chuck_Norris]

got a blaster that idles good and is good almost to mid throttle. at full throttle it acts like its starving for gas.once it is warmed up it runs perfect.i have cleaned carb checked all fuel supply even checked reed valves everything good , anyone have similar problems ??

make sure your jetting is correct for what mods apply.

[Alba450]

its worse with 2 strokes....with my cr 85 i would have to let is idle up to 2 minutes before running it full throttle 

I let my YFZ idle for 2 minutes and still isn't fully warmed up.


Let it set for atleast 3 MIN (Idle+small revs)

[snowmanzz13]

i had a problem where it starved like that, and it was the breather tube on the top of the gas cap, it was kinked, and as soon as unkinked it, it ran fine